12v 12Ah Valve Regulated Lead Acid Battery , Three Wheel Motorcycle Sealed Lead Acid Battery

Advantage of Chuangxiang motorcycle battery

Plate: Adopt unique formula improving utilization of active material in plate, in adition, high pure lead ingot(#1 lead purity is 99.99%) as raw material, so high cold cranking performance and low self discharge rate.

Seperator: Absorbed glass mat technology, superior ability of absorbing acid contributes to eliminate acid spill.

Terminal: High integrity of terminal sealing avoids acid leak, lead or copper terminal for choose.

Container: Reinforced ABS container great performance-resistance to gasoline and alcohol gasoline. Integrity of ABS container can resist the leak of gas and acid during the process of useage, it is environmental.

Quality control: All material must be strictly inspected before use, each process is strictly implemented by standard operation procedure, each product must be inspected before delivery to assure high quality product to client.

Characteristic of 12v 12Ah sealed valve regulated lead acid maintenance free motorcycle battery from China

1. Maintenance-free,completely sealed (all gases recycled internally)

2. AGM separator design eliminates acid spills

3. High integrity terminal seal

4. Self-regulating relief valve

5. Low self-discharge rate

6. Good effect of cold- starting performance

7. No PCL phenomenon

Answers to Common Questions about Batteries

1, When should I add water to my batteries?

How often you use and recharge your batteries will determine the frequency of watering. Also, using batteries in a hot climate will require more frequent watering. It is best to check your battery water level frequently and add distilled water when needed. Never add tap water to your battery. Tap water contains minerals that will reduce battery capacity and increase their self-discharge rate.

Warning - A brand new battery may have a low electrolyte level. Charge the battery first and then add water if needed. Adding water to a battery before charging may result in overflow of the electrolyte.

2, What is the proper electrolyte level?

Battery electrolyte levels should be just below the bottom of the vent well, about ½ - ¾ inch(13-19mm) above the tops of the separators. Never let the electrolyte level to drop below the top of the plates.

3, Do I ever need to add acid to my battery?

Under normal operating conditions, you never need to add acid. Only distilled or deionized water should be added to achieve the recommended electrolyte levels.

4, Can my batteries freeze?

If your battery is partially discharged, the electrolyte in a lead acid battery may freeze. At a 40% state of charge, electrolyte will freeze if the temperature drops to approximately -16 degrees F(-27℃). When a battery is fully charged the electrolyte will not freeze until the temperature drops to approximately -92 degrees F.(-68 ℃)